Led processor LVP603/LVP603S built-in LINSN TS801/LINSN TS802
installation guidelines
Applicable models and instructions
I. The guidelines LVP60xx contains the following models:
• LVP605 / LVP605S • LVP603 / LVP603S
Description: LVP60xx can be built one or two to send the card, for example of linsn:
1, built a 801 (or 802) Send card ,output screen resolution up to 1280 * 1024 (Built-in 802 sending card reach 1920 * 640)
2, built two 802 sent cards, by the the cascade maximum output resolution up to 1920 * 1080
II. the installation steps(A), install a LED send cards
1, Remove the chassis cover, remove the chassis bezel mounting studs in the corresponding position in order to load the corresponding brand of sending cards
2.Installation: Load LED transmission card, lock attached to a stud at A, lock attached hex screws on the DVI interface, and then the two-wire four-pin 5V power cable into sending cards PW1 position socket.
(B), installed two LED send cards
2. the installation of the second block of the LED send cards and lock of an M3 screw plug attached 5V power cable, and then use the hex screws DVI interface.
3, 10-pin ribbon cable at both ends were inserted into the two sending card RS232 Pin position ,RS232 data line parallel with the two sending cards, be sure one send card two sets of code in unallocated from the state (defined as card 1), another card code is in the ON state (defined as card 2), this dual Card Quad Ethernet port up to drive the LED screen point 1920*1080
4, external wiring diagram LVP60xx double sending card cascade. |