Power Supply
Methods: by Four-pin power connector/PCI slot Power supply/Power Jack (the middle pin of power jack is positive; the first pin of the four-pin power connector is positive, the fourth pin is near the PCI slot)
Specs: DC, 5V-6.3V, 2A
Communication Cable
Connecting the sending card USB-B port and the computer USB-A port
DVI transmission Cable
DVI cable: Connecting the sending card DVI port and the DVI-D port of computer graphics card
Set the DVI output of computer graphics card to CLONE mode, so the sending card is copying the content on computer monitor to LED Display
Network cable RJ45 transmission cable (568B-to-568B or 568A-to-568A)
U port means Upper port; it carries the upper half of the height
D port means Down port; it carries the lower half of the height
For example: TS801D sending card, in 1280*1024 resolution mode,
U port carries 1280*512 (Start Y: 0-512)
D port carries 1280*512 (Start Y: 513-1024)
After installation:
The LED indicators of sending card will be RED light on, and GREEN light flashing.
Power supply:
DC, 3.3-5V, 2A; by two-line power supply/Four-pin power supply
Network cable RJ45 transmission cable (568B-to-568B or 568A-to-568A)
Usually, A port gets input signals from sending card U port/D port
B port outputs signals to the next receiving card A port
In short, we call A in B out
After installation:
The LED indicators of receiving card will be RED light on, and GREEN light flashing.
When A in B out, green light flashing fast; when B in A out, green light flashing slowly
50-pin outputs
|