|
Set the Linsn LED Display Control System to work with LED Display.
LedStudio, Option, Software Setup;
Click anyplace that allows type in or just knock at keyboard “linsn”,
 Password 168
Display mode: choose the same resolution as computer monitor or as video processor output resolution
Note: LedStudio will detect the attached Sending Card Model and list the available resolutions.
Default: set the sending card to Default settings.
Click Save on sender.
Main card: which COM port is used for LedStudio to communicate with sending card
Sender Num: the quantity of sending card(s) connected to computer
Y Start: Auto or set the Y start of sending card. For example, 120, then the sending card will read data from 0,120 of computer desktop.
Set Width: set the pixel numbers that the sending card needs to carry, then it will enable more height for U RJ45 output.
Start X, Start Y: set (X, Y) for sending card to start reading data from computer desktop. Start X, Start Y is based on Y Start. For example, Y start (0, 120), StartX, Y (120, 120), then sending card start reading data from (120, 240) of computer desktop.
Note: in Screen Area, Start X, Start Y cannot be set beyond the RJ45 U port resolution; otherwise the led screen would freeze or appear wrong codec. In here, Start X, Start Y can set within the sending card resolution.
Width Height: it is same function as LedStudio, Option Meanu, Screen Area, Zoom Display. for example, a led display resolution is 96*64, to show a larger part of computer desktop like 288*192, then input width 96/288=0.33, height 64/192=0.32.
Manual Grey: change Grey instantly. 16bit（16384），32bit（32768），64bit（65536）
Screen power: to turn on/off enable LedStudio to control on/off
Screen power off: turn off sending card signal for output
Asyn mode: Not yet available
Hardware: show sending card info by clicking Check Hardware
Other: leave it empty.
Enable functions of control system. Leave it as default.
Use 10 bit colors: when 10 digit signal input is applied to TTL;
Use plug and play for DVI: automatically enable DVI port of graphic card;
Enable dot-correct for soft: enable dot correction effects;
Enable dot-correct for hardware: reserved for future development.
Use monitor for card/box: when enable, go to Option menu, Led Screen Monitor, will have Card/box monitor window, to read each receiving card firmware code and temperature and so on;
Use monitor for dot: reserved for future development;
Single color only: black and white color;
Enable ExCard Bright: enable function board automatically brightness adjustment function;
Remember LAN: only for non-sending card control mode;
Video card Frequency:: working frequency of current graphic card;
Port of hot backup: Select a port for backup data.
Change the color temperature on led display
Rotate: rotate image function realized by sending card, not by graphic card;
Leave it as default.
Make G-R-B 7-formed led display show virtual.
|
