Manual Brightness Adjustment
LED Display with Linsn 8th control system is needed.
1. Open LedStudio, “Option”-“software setup”-key in “linsn”-password “168” show as following:
Tick Enable dot-correct for soft in Sender tag, Save on sender
2. Upload the CORRECT *.RCG file and set the width and height, then send and save on receiver
3. Upload the CORRECT *.CON file from Display connection tag, by Load from file
Or Configure the CON file in DISPLAY CONNECTION, send and save the CON file.
4. Manually change the whole led display or single receiving card RGB Value
5. Change selected pixel(s) RGB value, Click Screen area color correction,
Select adjust brightness
Choose a correction mode from Software Single pixel, software2x2, software4x4, software8x8 Extsoftware
Details explanation
Note: hardware correction is to adjust the current of led display driver ic
Single pixel: pixel by pixel correction, choose this if one receiving card carries within 96*64
Software2X2: take two neighboring pixels in width and 2 neighboring pixels in height as one correction unit
ExtSoftware: enhanced software brightness correction, one receiving card supports 320*256 single pixel correction
Note: ExtsSoftware need firmware support. And different should select Exsoftware or (Single pixel/software2X2/software4X4/software8X8) accordingly
6. Select pixel(s) for adjustment
Select a color (Red/Green/Blue) to adjust
Click Inc. brightness/Dec. brightness/Adjust value
Inc. brightness: increase brightness
Dec. brightness: decrease brightness
Adjust value: change all pixels with Old Brightness Value to a New Brightness level
From file: load saved .RVS (correction info)
Save to file: after finishing manually brightness correction, save .RVS correction info to file.
Test: compare the effects with and without correction info
Save: save the .RVS file (correction info) in the flash memory of receiving card
7. Click Ok to exit |